How to remove the residual hot melt ashesive from the edge banding machine glue tank

Sep 10, 2025

Leave a message

                                                  How to remove the residual hot melt adhesive from the edge banding machine glue tank?

 

It is a bad habit to leave hot melt adhesive residue in the glue tank of the edge banding machine without cleaning it. If the hot melt adhesive in the glue tank is not cleaned for a long time, its edge banding performance will be affected.

 

Many edge banding factories don't pay much attention to how to remove hot melt adhesive from edge banding machines. However, the residue that accumulates in the adhesive tank over time is composed of carbonized and oxidized adhesive. The thicker the layer, the more it affects the heating performance of the edge banding machine. It also damages the properties of the melted adhesive and hinders its stability. Therefore, removing residual hot melt adhesive from the edge banding machine's adhesive tank is essential!

 

Removing residual hot melt adhesive from a canister is simple. To do this, place a T-shaped object into the adhesive while the adhesive is still molten. Allow the adhesive and the object to cool together. Then, when the adhesive in the canister is reheated, the adhesive in contact with the canister melts faster than the adhesive farther away. As soon as the adhesive melts, remove the T-shaped object and the adhesive block. This will leave only the adhesive remaining on the canister wall. At this point, use a mixture of 1:1 toluene and 1:1 methylene chloride to remove any remaining adhesive from the canister.

 

The method of clearing the residual low-temperature edge sealing hot melt adhesive in the glue tank is relatively simple and can be completed in a short time. It is also beneficial to the maintenance of the edge banding machine.

 

 

20250108170112

Send Inquiry